![background image](http://html.mh-extra.com/html/whynter/idc-221sc/idc-221sc_instruction-manual_978410008.webp)
8
INSTALLATION AND OPERATING INSTRUCTIONS
ICE MAKING INSTRUCTIONS
1. Turn the unit on by pressing the Power button.
2. Select desired ice size by pressing the ice size selector button (Small or Large).
3. Water will be pumped from the water reservoir to the water tray under the freezing bars. The freezing bars will
start freezing. Once the freezing process is complete, the freezing bars will heat up to drop the ice and the ice
shovel will push the ice down to the ice storage bin.
4. When the unit is used for the first time, discard the first couple batches of ice.
5. The unit will automatically check the water level in the reservoir periodically and will stop the ice-making cycle
when the unit detects any shortage of water.
MANUAL FILL METHOD:
When the water level is low, the water indicator will then start flashing. Press
the ON/OFF button to turn off the unit and fill the reservoir with water. Press the ON/OFF button again to restart
the ice-making cycle or wait 3 minutes after the water indicator stops flashing as the unit will begin it’s normal
operation cycle automatically.
DIRECT WATER CONNECTION METHOD:
Once the water reservoir is out of water, the unit will refill au-
tomatically up to the MAX line.
6. When the ice reaches the ice full sensor, the unit will stop operating and the ice full indicator will be displayed.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If unit is not in use,
drain all water left in the water reservoir.
When the ambient temperature is lower than 59ºF, the small ice size is recommended to avoid ice clump-
ing together. For best performance, water temperature should be between 55ºF and 85ºF and ambient
temperature between 65ºF and 77ºF.
The ice storage bin does not keep the ice frozen. The ice in the bin will slowly melt and the water will drip to
the water reservoir and reused.
DISPENSING ICE AND WATER
1. Place a glass or cup directly below the water and ice dispenser outlet.
2. To dispense ice, press the ICE button. Once the desired amount of ice has been dispensed, press the ice
dispenser button to stop.
To dispense water, press the WATER button. Once the desired amount of water has been dispensed, press
the WATER button to stop. This unit only dispenses room temperature water and/or water from the melted
ice. Water in the water reservoir is not refrigerated when unit is in operation.
NOTE:
As a default, the unit will dispense water for 10 seconds when the WATER button is pressed.
The water dispensing default time can be adjusted by holding the WATER button for 3 seconds. Then press
the Select button to choose the desired dispensing time from 7 seconds to 25 seconds. Press the WATER
button to confirm the selection.
WARNING:
Do not remove the glass or cup from below the dispensing outlet before the ice or water are finished dis-
pensing.