PAGE 6 – 498W & 499W
P
P
P
P
P
P
P
P
P
P
P
P
P
P
8.
Attach the Crown Moulding (I) and Base (J) by sliding the Rafi x Bolts into the Rafi x Cams.
Tighten the cams. See FIGURE 8.
SQUARE THE TOP SECTION:
9.
With the unit laying face down on a protective surface, measure from top left of unit to right
corner of Center Shelf (
/
) and from bottom left corner of Center Shelf to top right of unit
(
/
). Measurements should be equal. If line (
/
) is longer, tap left corner of Center Shelf
until measurements are equal. If line (
/
) is longer, tap right corner of Center Shelf. See
FIGURE 9.
Fasten the Upper Back Panel (K) to the unit through the pre-drilled holes in the back panel
using the #6 x 5/8" Philtruss Screw (P). Line up fl ush to top of Top Shelf and centered side to
side. Be careful not to over-tighten the screws as you might strip the wood.
FIG. 8
FIG. 9
x14
(498W)
x16
(499W)
P