Page 7 — 1323/1330AFGAC — 12/08
Fig. 8
Fig. 8a
8.
U
V
W
T
Fig. 7a
7.
Place the remaining Trestles (C and D) on the Pedestal Assembly. Face the Trestles with T-Nuts (D)
toward the ends of the Assembly from the center as shown in Figure 6. Insert ¼" x 2½" Hex Bolt (G)
and Washer (H). See Figures 7 and 7a.
DO NOT TIGHTEN BOLTS UNTIL YOU COMPLETE STEP 10.
On each inner pair of Trestles (C and D), place a Foot Assembly (U) between the two middle
trestles. Using a 3/32" or 2mm bit, drill three holes through each pair of trestles and foot assemblies
as shown in Figure 8a. Attach using six #8 x 2" Black Screws (T). See Figures 8 and 8a.
Untie the input jack and speaker wires that are affixed to the left pedestal and string them across
the frame and to the Amp located in the Right Pedestal.
DO NOT CONNECT THE WIRES TO THE
AMP YET.
Rotate the bed so the deckboards are face-up again.
Fig. 7
Trestles with T-Nuts face out
Trestles with T-Nuts face out
H
G
D
C
C
C
C
C
D
D
D
D
D
D
C
C
Pilot holes
that you drill
