Page 5 — 1321/1330AFGAC — 12/08
Remove Drawers (J & K) from Pedestal Kits (Z and Y). To remove drawers, push up on the left side
of the Drawer Release Lever while pushing down on the right Drawer Release Lever (see Figures
3 and 3a). Note where each drawer came from to ensure correct re-installation. (Positions are
marked on drawer backs.)
3.
Fig. 3
Fig. 3a
Drawer Release Lever
Trestle
with
removed
T-Nuts
Fig. 4b
Trestle with T-Nuts (D)
F
T-Nuts face out
T-Nuts face out
Place the trestle with the removed T-Nuts on the first rib by the speaker of the Right Pedestal (Z) and
run two ¼" x 1¾" Hex Bolts (F) and Washers (H) from the outside through the Trestle and into the
T-Nuts in the rib. See Figure 4 and 4a.
Install the remaining three Trestles with T-Nuts (D) with ¼" x 1¾" Hex Bolts (F) and Washers (H).
Position these Trestles so the T-Nuts face out as shown in Steps 4 and 4b.
NOTE: DO NOT TIGHTEN BOLTS UNTIL YOU COMPLETE STEP TEN.
How to identify whether a part is right or left: Stand and face the headboard and look to see
where the part will be used. If it fits on the left side of the headboard, it is a left kit part and
vice versa.
4.
Z
Fig. 4
H
F
Fig. 4a
H
1323 Right Pedestal Kit shown
Speaker
