Hb
Fb
Page 5 — 158Wb_11/09
4.
To align the Drawer Slide (U2) to the Left Side Assembly, place the end of the Drawer Slide (U2) that
has the wheel towards the Front Leg (A) and away from the the Back Leg (B). See Figure 4.
Align the first hole next to the slide wheel over the small pre-drilled hole in the End Apron (Ea) and
secure with one #6x5/8" Undercut Screw (V). Next, at the end opposite of the slide wheel, align the
bottom edge of the Slide (U2) to the bottom edge of the End Apron (Ea). Hold the slide in place and
secure with two #6x5/8" Undercut Screws (V) through the two remaining smaller diameter holes in
the slide. See Figure 4a.
Repeat to secure the Drawer Slide (U1) to the Right Side Assembly. See Figure 4b.
5.
Place the Top Assembly (Hb) face-down on a clean, protected surface. Spread a thin layer of glue into
the two dowel holes the the leg. Attach the Left Side Assembly to the Top Assembly (Hb) by sliding the
Rafix Cams (M) in the side assembly over the the Rafix Bolts (N) in the top and inserting the wood
dowels in the Back Apron (Fb) into the leg. Gently tap with a rubber mallet and quickly wipe away
any excess glue. Secure with one #8x1¼" Pan Head Screw (Q) through the back apron pocket hole
and into the leg. See Figure 5.
Fig. 4
U1
Fig. 4b
U2
Ea
Ea
Fig. 5
Left
Side
Assembly
Right
Side
Assembly
Fig. 4a
Stain test area.
M
B
C
A
D
V x 6
Q x 1
The drawer slide is stamped with an
“L” for left or an “R” for right in the center
of the wheels. Or they are stamped on
the body of the slide: “CL” for cabinet
left; “CR” for cabinet right.
V
V
V
V
V
V
Q
N
