White's 1142650, User Manual

Page: 7 / 26

GM24k Quick Start
Factory Reset
Hold when turning on the detector. Press and
hold button when “Fd” is on screen to reset
the machine to factory default.
Goldmaster 24k User Manual
7
1
2
3
4
5
6
7
8
9
10
*
If you attempt to demonstrate or test the
GM24k by waving targets in the air in
front of the search coil, it is ESSENTIAL
to have the GROUND BALANCE toggle
in the LOCKED setting.
This is necessary, for when the GM24k is
in the XGB setting, the searchcoil must
SEE ground while it is passing over the
target or it will think that the target IS
ground and will attempt to track it out.
This is the case whether you are demon-
strating with or without Iron Cancel.
You may, however, demonstrate the fast
ground balancing feature of XGB or
GRAB by waving or pumping a mineral-
ized rock in the air in front of the search
coil.
Thus, testing the GM24k with targets
while in XGB mode must be done in or
on the ground.
SPECIAL NOTICE
Quick Start
Instructions
With the GM24k properly assembled and the
batteries installed, follow the instructions below to
start finding nuggets.
Turn the
GM24
k on by pressing the POWER
button.
Set the
VOLUME to your preference (tap
Speaker icon, use Up and Down buttons).
Set the
THRESHOLD
to a faint hum (hold
Speaker icon, use Up and Down buttons). For
silent search, turn this all the way down.
Set the SENSITIVITY to a level that ensures
smooth operation (Up and Down buttons).
Set the
SAT (Self Adjusting Threshold)
to
get a stable threshold (hold Music button, use
Up and Down buttons).
Select your preferred
AUDIO mode (tap
Music button). With the Music icon displayed
you are in Beep mode. With no icon, you are
in
Zip
mode.
Enable IRON CANCEL if you experience
difficult ground conditions, hot and cold
rocks, or iron trash (tap Nail button).
Lower the search coil to the ground, then
“pump” the coil up and down a couple of
times and
XGB (Xtreme Ground Balance)
will automatically balance or track out the
ground mineralization. Or you can Lock the
tracking (Lock button) and perform a ground
grab (Bullseye button).
Start
swinging the search coil
in wide
sweeps that overlap each other.
If you experience false signals or constant
beeping or popping , turn SENSITIVITY
down a bit, adjust the SAT up, or enable
IRON CANCEL.