WHITEHALL MANUFACTURING
• P.O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
4
Instructions for Operation and Care of Water Bath SP-1600-A
When raising temperature, allow the temperature to
stabilize and read the water temperature on the digital
thermometer above the knob. Keep lid closed while unit is
heating up.
When lowering temperature, allow the temperature to
stabilize and read the water temperature on the digital
thermometer above the knob. Keep lid open while unit is
cooling down.
Close lid.
O OFF
Locate the Power Switch at front of the appliance and
make sure it is set to "OFF" (the switch will not be lit).
Insert connector end of power cordset into power inlet at
side of appliance.
| ON
Caution! Lid can pinch fingers.
Connect plug end of power cordset into a G.F.C.I.
protected AC electrical receptacle.
You are now ready to turn "ON" the appliance. Locate
the Power Switch at the front of the unit and press to
"ON" position causing the switch to light.
6. Preparing to turn "ON" your Water Bath
7. Turning "ON" your Water Bath
Note: Thermal Overheating Sensor is set to shut down
unit at temperatures of 215°F (102°C) and above.
(Caution: Unit will automatically turn back on once the
temperature has dropped to lower temperature.)
Your water temperature is adjustable and can be set to
reach splint materials recommended operating
temperature. (See splint manufacturer's instructions.)
Note: Most splint material on the market today, has an
operating range between 113°F (45°C) to 200°F (93°C).
Your Water Bath is capable of approximate maximum
temperature of 200°F (93°C), depending on amount of
water in unit.
The thermostat is very sensitive, even a small
adjustment can raise or lower the temperature several
degrees. To adjust the temperature, turn black knob at
the lower right hand side of unit:
8. Changing the temperature on your Water Bath
TO RAISE TEMPERATURE
TO LOWER TEMPERATURE
SET-UP INSTRUCTIONS
(continued)
DO NOT use any medium except water.
Check drain valve and make sure handle is in the
"closed position" by turning clockwise to make certain no
water in tank will drain out of appliance while being filled.
4. Preparing to Fill your Water Bath
Make sure appliance is unplugged and all packaging has
been removed from reservoir. Ensure that the inside of
tank is thoroughly clean before filling with water.
5. Filling your Water Bath
Appliance must be unplugged. Fill appliance with water
to line labeled "FILL TO LINE", which is located
inside tank side.
Ball valve closed
FILL TO LINE
WARNING
!
Use the Water Bath only as directed in this manual.
Any other use can cause injury.
WARNING
!
Note:
We recommend the use of
distilled water to reduce the build-
up of mineral deposits and dirt.
