White-Westinghouse 943006197, User Manual

Page: 26 / 36

WARNING!
Refer to Safety chapters.
What to do if...
PROBLEM POSSIBLE CAUSE REMEDY
There is no spark when you
try to activate the spark
generator.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
There is no spark when you
try to activate the spark
generator.
The fuse is released. Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
There is no spark when you
try to activate the spark
generator.
Burner cap and crown are
placed incorrectly.
Place the burner cap and
crown correctly.
The flame extinguishes im-
mediately after ignition.
Thermocouple is not heated
up sufficiently.
After lightning the flame,
keep the spark generator ac-
tivated for equal or less than
10 seconds
The flame ring is uneven. Burner crown is blocked with
food residues.
Make sure that the injector
is not blocked and the burn-
er crown is clean.
The burners do not work. There is no gas supply. Check the gas connection.
The flame colour is orange
or yellow.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
The turnspit does not rotate. The turnspit is not correctly
installed into the turnspit
hole.
Refer to "Using the turn-
spit".
26
TROUBLESHOOTING