24
You must complete steps 2
through 4 within one minute. If
you do not complete these steps
within one minute, start again at
step 1.
1. Look at your programming plan
table 3 to determine your first
planned “begin setback” time, then
press and hold the
time set
button
until this time is displayed (also
check the display for the correct AM
or PM mode).
2. Press the
setback button
.
3. Check the display. The setback
indicator arrow should be on.
4. Look at your programming plan
table 3 to determine your first
planned “end setback “time, then
press and hold the
time set button
until this time is displayed.
5. Press the
setback button
.
6. Check the display. The setback
indicator arrow should be off.
Your first setback time is programmed!
To program all the setbacks you want,
just repeat steps 1 through 6 for each
begin/end setback time period. After
you have programmed all desired
setback time periods , you may want to
review your programmed setback
periods. If so, proceed to step 7. If you
don’t want to review your programming,
omit step 7 and proceed to step 8.
NOTE