White Outdoor 24AD595C190, Operator'S Manual

Page: 8 / 20

8
Attaching Engine-Pump Assembly
(See Figure 7)
• Place the engine and pump assembly in position on
the engine mounting bracket with the pump facing
out.
• Align holes in base of engine with appropriate holes
in engine mounting bracket.
• Secure the engine and pump assembly with four
hex bolts, lock washers, and hex nuts found packed
with the Operator’s Manual.
• Secure with lock washers and hex nuts. Tighten to
14 ft-lbs.
Figure 7
Attaching The Hoses
Suction Hose (See Figure 8)
• The suction is attached to the reservoir tank,
beneath the engine mounting bracket. Loosen the
hose clamp on the free end of the hose. Remove
any protective insert from the end of the hose.
Figure 8
• Remove the protective cap from the fitting on the
bottom of the pump (some oil may flow from pump).
Attach the end of the suction hose to the fitting on
the bottom of the pump. Place the hose clamp at
the base of the fitting and tighten securely.
Pressure Hose (See Figure 8)
The pressure hose is attached to the control valve.
Route the hose between the beam and the tongue.
Secure the pressure hose to the adapter on the top of
the pump.
Return Hose (See Figure 9)
• The return hose is attached to the top of the control
valve. Loosen the hose clamp on the free end of the
hose. Cut the securing strap. Remove any
protective insert from the end of the hose.
• Remove the protective cap from the fitting on top of
the filter head. Attach the end of the hose to the
fitting on top of the filter. Place the hose clamp at
the base of the fitting and tighten securely.
Figure 9
Attaching The Log Cradle
• Pull the beam lock on the beam support/latch
bracket out and pivot it down. Carefully lower the
wedge, beam, and cylinder assembly to the
horizontal position. Pull out and rotate beam lock to
secure beam in the horizontal position.
NOTE: The hardware for attaching the log cradle may
be found packed with the Operator’s Manual.
• Place one cradle support bracket against the lower
outside surface of one of the beam flanges.
See Figure 10.
• Insert two carriage bolts through the cradle support
bracket and the beam flange. Secure with two
flange lock nuts. Do not tighten at this time.
Engine
Mounting
Bracket
Pump
Facing
Out
Hex
Bolts
Hex
Nuts
Lock
Washer
Reservoir
Tank
Attached
Attached To
Reservoir Tank
To Engine
Suction Hose
Pump
Pressure
Hose
Clamp
Hose
Attached To
Attached
Reservoir Tank
To Cylinder
Control Valve
Return Hose Filter
Filter
Head
Hose
Clamp