•
Place the trapeze lines on each side of the mast (one red and one green on each side)
•
Make sure the trapeze line with the stainless eye just above the handle is the front one, this will be
used to hold the foil up when on land.
•
Place the forestay, both shrouds and jib block on the lower shackle make sure that the shrouds are
on the out side and the jib halyard and forestay are in the middle (see photo).
•
Run the jib halyard through the loose block with the shackle attached, then run the halyard back up
though the top block, and tie the sacrificial jib halyard on, as it wont have enough length by its self
(see diagram)
•
Run the kite halyard down the mast, make sure the end which will attach to the kite head is in front
of everything with the other end behind everything then running thought the cleat at bottom.
•
It is better if you tie off everything at the bottom of the mast to stop the lines getting tangled when
erecting the mast
Shroud
Trapeze
Forestay
Jib Halyard
Mast
Block
Jib halyard
Sacrificial
halyard
Jib shackle
Hounds
Mast Setup
4
