MAINTENANCE
26
September 2008 / W-SC6/10 for mobile applications / EN
A smeer of oil has to be put on the seal of the filter before
fitting the filter. The filter should be fastened manually:
when the rubber touches the metal turn 3/4 further.
4.2.6
Readjustment V-beltplacing oil filter
The alternator bracket allows for readjust of the V-belt.
Deflections should be 10 mm (refer to fig. 22)
4.2.7
Air strainer element
The W-SC6 / SC10 for mobile applications is standard
supplied with an air strainer element (figure 23). Strainer
change depends on environmental contamination. Check
the air strainer at least every 500 running hours. The
strainer can be cleaned by washing in petrol or solvent
4.3
REGULAR MAINTENANCE
CHECK DAILY:
Oil level (see fig. 24)
Take care the oil level is never
below the mark. Do not add oil
when the level is still above
the mark
1
Minimum oil level
2
Maximum oil level
Fig. 24:
CHECK DAILY:
Level cooling liquid
Hoses for loose connections or deterioration.
AFTER FIRST 50 HOURS:
Change oil and replace the oil filter.
Have the engine run until it is on temperature and
stop it. Replace the oil filter. Drain oil by the sump
pump into a suitable retainer and fill up with fresh
oil. Start the engine again and have it run for 5
minutes. Stop the engine again and pause for a
few minutes to let the oil gather in the crankcase.
Check the level again and add oil when
necessary.
Check and tighten nuts, bolts, and unions, paying
particular attention to the fuel system.
Observe the exhaust at the normal full load. The
exhaust must be free from soot. Do not allow the
engine to run with a dirty exhaust without
investigating the cause as this may result in an
expensive breakdown.
Check and readjust V-belt.
Check the electrical connections.
EVERY 150 HOURS:
Change oil.
Check the battery acid level (not applicable when
Whisper Power batteries are used).
Check battery terminals for corrosion
Check and readjust V-belt
Fig. 21
Fig. 22
Fig. 23