Slimline LS
www.whisperkool.com | Page 11
PREPARING THE INSTALLATION LOCATION
Minimum Tools Needed
Hammer
Saw
Screwdriver
Level
Note: The following installation examples are for reference only. Door header construction and framing may vary.
When not installing above a door, you must have adequate framing inside of the wall. WhisperKOOL recommends
consulting a licensed contractor for framing and construction needs.
STEP 1
Locate the desired installation location. Using a level and a
pencil, mark the center line. Outline a rectangle 103/4” by 221/2”
where the unit will be placed into the wall.
STEP 2
Using a saw, cut the hole in the drywall and wall stud(s). Be
careful not to cut into any electrical lines or plumbing.
STEP 3
In most cases, framing will need to be added to provide
adequate support for the unit and mounting bracket.
Door Opening
221/2”
103/4”
*approx. 1” from door casing recommended
*approx. 1” from door casing recommended
*approx. 4” from ceiling recommended
Center Line
