Fitting Kit
EN
K325W
●
Select plastic packer blocks from fitting kit
and insert into fixed-points. Blocks have L
& R which should be read from beside
vehicle. "L" should point to your left and "R"
should point to your right.
●
Position crossbar so hole in centre of metal
loadplate lines up through packer block
with threaded insert in fixed-point. If
standing on the right side of vehicle, use
hole marked "R". If on the left use hole
marked "L".
●
Tighten adjusting screw to 5 Nm (3.7 ft lb).
●
When fitting type B crossbars, tighten using
Hex Key located inside one of the right
hand side covers to assist.
●
Using long capscrew and washer, secure
assembly onto leg (use Hex Screwdriver
supplied with crossbar to assist).
11