Whispbar K089, Fitting Instructions For Basic Carrier

Page: 8 / 79

Fitting Kit
EN
K089W
●
Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●
Please check the rear of this manual for
information relating specifically to your
vehicle.
●
Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
●
Ensure that the crossbar is adjusted evenly
at both ends.
●
Ensure the clamp pin is inserted into the
fixed point and the clamp sits flat to the
body side.
●
Repeat for all four positions.
●
Refit rubber seal over the clamp.
●
Tighten adjusting screw to 5 Nm (3.7 ft lb).
8