15
Troubleshooting
No audio at all
o
Check that all the connections are secure and in the right places.
o
Test all cables.
o
Check that all components are powered up.
o
Use another speaker to test that there is a signal.
Audio from only woofer or only electrostatic panel
o
Double check that sound is equalised correctly.
o
Check that bass and treble adjustment knobs are set correctly.
o
Likely this is an internal fault, contact your dealer for service information.
Indistinct Sound Image
o
Are you using the speaker-input terminals? Check to make sure you have
wired them correctly and in-phase.
o
Try adjusting the positioning or direction of the speakers.
Excessively high or low bass
o
Try adjusting the 80 Hz and 250 Hz knobs.
o
Try moving the speakers, test different distances from the wall.
Popping, crackling, hissing noises
o
This is normal on start-up for electrostatic panels, particularly if they have not
been used for some time. Wait and see if it stops in time.
o
Vacuum clean the electrostatic speaker panel. Be sure to turn the speaker off
and wait 5 minutes before proceeding.
o
If sounds continue, turn speakers off, unplug and wait 30 minutes.
o
If sounds continue after this your speaker may require servicing, contact your
dealer for information.
Please note:
It is better to leave the loudspeakers permanently plugged into the
mains supply and switched on, as this keeps the panels dry and dust-free.
For further information, contact our Service Department at
.