24
2.
Move the door strike
Using a T25
®
screwdriver, remove the two screws securing
the door strike to the door frame of the dryer. Remove the
four screws above and below the door strike and set aside
for later use. Rotate the strike 180° and attach to the opposite
side of dryer door frame, as shown.
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 13 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
NOTE:
There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar fl at object between the inner
and outer doors at the locations shown to release the tab.
Release tab
4.
Remove hinge and latch
from inner door
Using a T25
®
screwdriver, remove the three screws securing
the latch plate and the fi ve screws holding the hinge assembly
in place.
Hinge
Latch
Release tab
1.
Remove door from dryer
Using a T25
®
screwdriver, remove the four screws securing
the door hinge to the dryer and lift up and out to remove
the door. Place the door on a soft towel or other non-scratch
surface. Retain or set aside the four screws.
Reverse door swing: square-shaped door
Summary of Contents for YWED85HEFC2
Page 2: ...2 DRYER SAFETY ...
Page 26: ...26 SÉCURITÉ DE LA SÉCHEUSE ...