Whirlpool XWT-608, Service Manual

Page: 2 / 6

impeller and its bearing is
loose.
6. Over loaded.
7. The space for motor running
is not enough or the capacitor
is weak.
Normal and gentle
wash program do
not work correctly.
Or do not run
clockwise and anti-
clockwise. 1. The spring reed of switch
selector is broken.
2. The spring reed of wash timer
is broken or become aging.
3. The wash motor is broken.
1. Replace the switch selector.
2. Replace the wash timer.
3. Replace the wash motor.
Troubles Reasons How to solve.
Fail to spin and the
spin motor is not
working 1. The fuse is blown.
2. The micro-motion switcher
not connected well or the
spring reed is broken.
3. The connection of the power
trans harness is not ok.
4. The capacitor is broken.
5. The spin timer is broken.
6. The spin motor is broken.
1. Replace the fuse. Check the connection to ensure
in safety condition.
2. Press down the upper spring reed so as to enhance
the contact between reeds. Replace the spring if
it’s broken. Burnish the spring if it’s covered by
oxidation.
3. Check the harness.
4. Replace the capacitor.
5. Replace the spin timer.
6. Replace the spin motor. If the breakage was
caused by water-leak, check what caused it.
No spinning, but
the spin motor is
working.
1 Clothes wrap the bearing of
spin tub.
2 The fasten screw fixing the
bearing of spin motor and
coupler is loose.
3 The coupler is braked by the
brake wheel.
4 The capacitor is weak.
The fasten screw fixing bearing of spin
motor and coupler is loose. Or the inner
wrap of coupler wore out.
1 Remove the fixed cover and take out the clothes
and exterior material.
2 Tighten the fasten screw.
3 Hang back the brake wire if it’s loose. Adjust the
position if the distance between brake wire and
steel wire rope is too short. Replace the spring if it
is aging.
4 Replace the capacitor.
5 Tighten the fasten screws. Replace the inner wrap
of coupler if it’s wore out.
Spinning lasts
too long. The inner
tub crashes the out
tub when running.
1. Clothes in the spin tub is not
even.
2. Over-loaded.
3. Drain hose is not laid down.
4. The three spring sleeves of
spin motor were not fixed
well.
5. The running dimension for
1. Replace the clothes evenly.
2. Take out some clothes till the volume is suitable.
3. Lay down the drain hose until the inner water is
drained out.
4. Adjust the three spring sleeves until level.
5. Replace the spin motor.
6. Replace the capacitor.
2