12
Programming the Water Softener
SET WATER HARDNESS NUMBER
1
. Press the PROGRAM button once again to display
a flashing “25” and the word “HARDNESS”.
Questions? Call Toll Free 1-866-986-3223
Monday- Friday, 8 AM - 7 PM EST
or visit www.whirlpoolwatersofteners.com
When you call, please be prepared to provide the model and serial number,
found on the rating decal, located on the back of the controller’s top cover.
PROGRAM THE SOFTENER
When the power supply is plugged into the electrical
outlet, the model code (LL60) and a test number
(example: J3.8), are briefly shown in the display.
Then the words “PRESENT TIME” appear and 12:00
PM begins to flash.
SET TIME OF DAY
If the words “PRESENT TIME" do not show in the dis-
play, press the PROGRAM button until they do.
1
. Press the
r
UP or
s
DOWN buttons to set the
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
NOTE:
Press buttons and quickly release to slowly
advance the display. Hold the buttons down
for fast advance.
RECHARGE
PROGRAM
DATA
HOLD TO START
PRESS TO SCHEDULE
FIG. 16
PROGRAM button
DOWN button
Display
RECHARGE button
DATA button
UP button
FIG. 17
FIG. 18
2
. Press the
r
UP or
s
DOWN buttons to set your
water’s hardness number.
NOTE:
If your water supply contains iron, compen-
sate for it by adding to the water hardness
number. For example, assume your water is
20 gpg hard and contains 2 ppm iron. Add 5
to the hardness number for each 1 ppm of
iron. In this example, you would use 30 for
your hardness number.
20 gpg hardness
2 ppm iron x 5 = 10 +10
(times)
30 HARDNESS NUMBER
3
. Press the PROGRAM button once again to return
to normal operating display.
continued on next page
