4-8
n
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
COMPONENT ACCESS
To Remove the Belt and Drum
1.
Unplug dryer or disconnect power.
2.
Perform the procedures on page 4-4, “Removing the
Top Panel” and “Removing the Console/UI” prior to
performing the following steps.
3.
Perform the procedures on page 4-6, “Removing the Front
Panel” prior to performing the following steps.
4.
Remove front 1/4” hex-head screw securing the control
bracket to the console bracket...or remove the entire
control bracket (see Figure 1).
Front Control Bracket Screw
Figure 1
5.
Remove the four (4) 1/4” hex-head screws from the front
console bracket and remove bracket (see Figure 2).
Console Bracket Screws
Figure 2
Removing the Belt, Drum, and Rollers
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
6.
Disconnect Moisture Sensor connector (see Figure 3).
Moisture Sensor
Connector
Figure 3
7.
Remove the four (4) 1/4” hex-head screws from the lint
duct as illustrated in Figure 4. Swivel the lint duct down
from the bulkhead and remove.
Swivel down and
remove lint duct.
Figure 4