4-4
n
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
COMPONENT ACCESS
Removing the Top Panel & User Interface
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Top Panel
1.
Unplug dryer or disconnect power.
2.
Remove the three (3) 1/4” hex-head screws from the top
panel as illustrated in Figure 1.
Top Panel Screws
Figure 1
3.
Lift the rear of the top panel, pull back, and remove top
panel from the dryer.
To Remove the Console/User Interface
1.
After removing the top panel, remove the User Interface
connector J2 from the Appliance Control Unit (ACU).
Unclip UI harness from bracket (see Figure 2).
Unclip From Bracket
J2 Connector
Figure 2
2.
Remove the two (2) 1/4” hex head screws securing the
console to the cabinet (locations circled in Figure 3).
Figure 3
3.
Using a flat blade screwdriver, Insert tip of screwdriver
between the clip and tab and gently pull down to
separate. Perform the procedure with all four (4) clips. See
Figures 4 and 5.
Figure 5
4.
Lift up on back of UI and disengage assembly from dryer.
5.
To reinstall the UI assembly insert the hooks on the front
of the UI into the clip openings on the console frame (as
shown in Figure 6). Insure the hooks are all fully inserted.
Next, firmly push down on the clips until you hear them
snap into place. Reinstall the two (2) 1/4” hex-head screws
to secure the UI in place.
Figure 6
Figure 4
