![background image](http://html.mh-extra.com/html/whirlpool/weg515s0fv0/weg515s0fv0_installation-instructions-manual_971558018.webp)
18
4.
Remove 2 screws from the bake burner.
5.
Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orifice, and set the bake burner aside. Do not
disconnect the wire.
6.
Apply masking tape to the end of a
3
/
8
" (1 cm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning the Propane gas bake burner orifice
spud counterclockwise to remove. The spud will be stamped
with a “56.”
7.
Replace the “56” spud with a “47” spud. Install the Natural
gas bake burner orifice spud, turning it clockwise until snug.
IMPORTANT:
Do not overtighten.
8.
Position the back of the bake burner over the oven orifice,
and then align the holes for the screws.
9.
Reattach the bake burner with 2 screws.
A
B
A. Bake burner
B. Screws
A
A. Oven orifice
A
A. Orifice spud
10.
Position the front of the oven bottom panel toward the front
frame, and then lower the rear of the oven bottom panel into
the oven.
11.
Reattach the oven bottom panel with 2 screws and
2 washers.
To Convert Oven Broil Burner (Propane Gas to Natural
Gas) (on some models)
1.
Remove 1 screw from the broil burner.
2.
Remove the flame spreader.
3.
Remove the broil burner from the broil burner orifice hood.
NOTE:
The broil burner will hang in the back of the oven
while you are changing the orifice hood.
4.
Apply masking tape to the end of a
3
/
8
" (1 cm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning the Propane gas broil burner orifice
hood counterclockwise to remove. The hood will be stamped
with a “100.”
5.
Replace the “100” hood with a “155” hood. Install the Natural
gas broiler burner orifice hood, turning it clockwise until snug.
IMPORTANT:
Do not overtighten.
6.
Place the broil burner on the broil burner orifice hood.
Insert the broil burner ceramic igniter in the hole in the
rear of the oven.
7.
Replace the flame spreader with all 4 tabs facing up and the
notches toward the rear of the oven.
8.
Position the broil burner against the top of the oven and
attach it with 1 screw.
9.
Replace the storage drawer. See the “Remove/Replace
Drawer” section.
10.
Replace the oven door. See the “Oven Door” section.
11.
Replace the oven racks.
C
D
A
B
A. Broil burner
B. Flame spreader
C. Screws
D. Orifice hood
x.xx
A
A. Orifice hood