6
INSTaLLaTION INSTrUCTIONS
Before you start: disconnect power.
INSTaLL STraIN reLIef
1.
Remove terminal block cover
Remove hold-down screw and terminal block cover.
Attach power supply cord strain
relief
Remove screws from 3/4" (19 mm) UL listed strain relief (UL
marking on strain relief). Put two clamp section tabs into hole
below terminal block opening with one tab pointing up and one
pointing down. Hold in place and tighten strain relief screws
enough to hold two clamp sections together.
Put power supply cord through strain relief. Be sure that wire
insulation on power cord is inside strain relief. Strain relief should
be a tight fit with dryer cabinet and be in a horizontal position.
Do not tighten strain relief screws at this point.
Now skip to
step 6.
Attach power supply cord
to strain relief
2.
3.
If installing power supply cord strain relief, continue with
steps 2-3.
If installing direct wire strain relief, continue with steps 4-5.
Power supply cord strain relief:
