3
Parts needed:
(Not supplied with washer)
Check local codes. Check existing electrical supply and venting.
See “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
LOCaTION reQUIreMeNTS
DRYER DIMENSIONS
27"
(686 mm)
3
/
4
"
(18 mm)
35
3
/
8
"
(899 mm)
Left or
right side
exhaust
3
1
/
2
"
(89 mm)
6
7
/
8
"
(173.5 mm)
29"
(736 mm)
Electric
6
1
/
4
"
(159 mm)
28
1
/
8
"
(715 mm)
3
1
/
2
"
(89 mm)
14"
(358 mm)
IMPORTANT:
Do not operate, install or store dryer where
it will be exposed to water, weather, or at temperatures below
45° F (7° C). Lower temperatures may cause dryer not to
shut off at end of automatic sensor cycles, resulting in longer
drying times.
NOTE:
Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See
“Venting Requirements.”
Front view:
Back view:
Side view:
Mobile home - Additional installation requirements:
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile home construction
and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240
MH.
Mobile home installations require:
n
Metal exhaust system hardware, available for purchase from
your dealer. For further information, see “Assistance or
Service” section in your Use and Care Guide.
n
Special provisions must be made in mobile homes to introduce
outside air into dryer. Openings (such as a nearby window)
should be at least twice as large as dryer exhaust opening.
*
* Approx. measurement
