Whirlpool WDC 1070SL, Service Manual

Page: 6 / 50

2.5 Installing the bottom cover
In order to provide a quieter environment laundry, a bottom cover plate is provided in some machines, if it is
installed in the bottom of the washing machine section, can significantly reduce noise.
However, this part is not installed, you can normally use the washing machine. After washing machine tilting 30 ° -
40 °, the bottom cover is affixed with sound-absorbing cotton side up, printed with "PUMP" (pump) the right
corner that is placed in the washing machine
The position of the pump, and then fasten the bottom plate, flat washing machine can be.
2.6 Connection inlet
If the inlet hose is not installed on the washing
machine, you must install it tightly to the inlet valve.
Depending on the model, some washing machines
may also have a hot water inlet valve.
If the model has both hot and cold inlet valve; the
blue-colored inlet hose should be connected to the
cold water inlet valve, and the red-colored inlet
hose should be connected to the hot water inlet
valve. Lastly, connect the other end of the hose to
the faucet.
NOTE:
Make sure that there are no kinks on knots on the inlet hose.
Hot water line should not be connected to machines with no hot water inlet valves.
Hot water washing machine cannot be connected to storage water heaters without pressure.
After connecting the inlet pipe, open the faucet to check for leaks.
Regularly check whether the inlet pipe brittle, cracking, and replace if necessary.