19
level Washer/DrYer
IMPORTANT:
Level washer/dryer properly to reduce excess
noise and vibration.
If washer/dryer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer/dryer cabinet. Then
turn the leveling foot clockwise to lower the washer/dryer or
counterclockwise to raise the washer/dryer. Recheck levelness
of washer/dryer and repeat as needed.
HELPFUL TIP:
You may want to prop up front of washer/dryer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer/dryer.
With washer/dryer in its final location, place a level on top
edges of washer/dryer. Use side seam as a guide to check
levelness of sides. Check levelness of front using lid, as
shown. Rock washer/dryer back and forth to make sure all
four feet make solid contact with floor. If washer/dryer is level,
skip to step 2.
1.
check levelness of washer/dryer
Place level here
Place level here
2.
Adjust leveling feet
Jam nut
Not Level
LEvEL
Not Level
When washer/dryer is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise on
leveling feet tightly against washer/dryer cabinet.
HELPFUL TIP:
You may want to prop washer/dryer with
a wooden block.
3.
Tighten leveling feet
Jam nut
For mobile home use:
Washer/dryers with gas dryers must
be securely fastened to the floor.
Mobile home installations require a Mobile Home Installation
Kit. See “Tools and Parts” section for information on ordering.
4.
Fasten washer/dryer to floor
(if needed)
Summary of Contents for W10356101A
