25
Failure - cause - solution
Failure / Fault
Possible cause
remedy
No water running?
- Filter valves closed
- Filter valves clogged
- Hoses twisted/kinked
- Power supplier / socket
faulty
- Power supply faulty
- Connecting cable/connector
between the knob and con-
trol unit faulty/damaged
- Control knob faulty/blocked
- Electronic device faulty
- Open filter valves
- Clean filters
- Connect hoses correctly
- Check power supplier and
socket
- Replace power supply
- Check connection and if
problem persists, contact
customer service
- Check control knob
- Contact customer service
Water running constantly?
- Electronic device faulty
- Turn the tap off and on. If
problem persists, contact
customer service
Water flow too low?
- Supply pressure too low
- Filter valves not open
enough
- Filter valves clogged
- Check supply line
- Open filter valves further
- Clean filters
Water temperature cannot be
adjusted?
- Water supply failure or tem-
perature difference between
hot and cold water supply
line too low
- Dirty filter taps
- Control unit fault
- Check water supply
- Clean filters
- Contact customer service
Dripping tap?
- Electronic device faulty
- Turn the tap OFF and ON
again. If problem persists,
contact customer service
Minimum flow rate too high?
Either completely hot or
completely cold water cannot
be obtained?
- Control unit reset error
- Turn control unit off, wait 5
seconds and turn back on. If
the problem persists, contact
customer service
notE:
The device must be turned off by disconnecting the power supply unit and removing the batteries.
EnglIsh
Summary of Contents for PM05016
Page 27: ......
Page 28: ...ET xxxxx R0 ...
