Whirlpool PACHW2900CO, Instructions For Use Manual

Page: 14 / 20

- 14 -
Remote controller
Insert the batteries into RC
1. Insert a pin and gently press down on the battery
cover and push in the direction of the arrow to
remove, as shown.
2. Insert 2 AAA batteries (1.5V) into the compartment.
Ensure that “+” and “-” polarity is correctly positioned.
3. Close the battery cover on the remote control.
•
Remote Control presetting
Each time the batteries are replaced in the remote
controller, the remote controller pre-set at Heat Pump
mode. The heat pump AC remote controller can be used
to control the cool only AC models.
• The remote control will operate the air conditioner at a
distance of up to 7m.
Use RC to control the appliance
• To operate the appliance by remote control, point the
remote control at the receiving device on the indoor
unit, to ensure receiving sensibility.
• To send a message from remote control, the symbol
will flash for 1 second. On receipt of the message, the
appliance will emit a beep.
Signal receptor/
display