21
Oven Racks
Manual sliding
The oven has 5 different rack positions. There is a bump in the oven rails that stop the rack from
falling when they are slide out.
To change the position of the racks follow these steps:
1. Pull the oven rack out until the bump.
2. Lift the rack from the front.
3. Pull out again to release the rack.
4. Choose the new rack position.
5. Place the shelf and push it until the bump.
6. Lift the rack from the front.
7. Push the rack again until you can feel the back wall of the oven with the rack.
Your range is equipped with an oven light (some models), this is a very important feature that
allows you to check the food without opening the door.
The oven light turns on when the light button is pressed
next to the knob on the end (some models).
To turn off the light, press the button again, in model with full oven control, oven control use (below section).
When the light bulb is blown, replace it following these steps:
1. Unplug the range cable or disconnect the power supply.
2. Remove the light bulb unscrew counterclockwise.
3. Replace with a new especial 40 Watts light bulb for appliances.
4. Reconnect the range or turn on the power supply.
Oven Control Use (Some Models)
Display
When power is first supplied to the appliance, a flashing time will appear on the display. Press OFF/CANCEL to clear flashing time from the
display.
If flashing time appears, a power failure has occurred. Press OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show either hours and minutes and seconds.
Oven indicator light
The indicator light are located on both sides of the display. The indicator lights light up or flash when the oven is one of the following
modes: Bake, Broil or Timer.
Start
Start begins any oven function. If Stars is not pressed within 5 seconds after pressing
a function pad, the push to Start (“PSH”) indicator
light will flash and the push to start tone will sound as a reminder
If Start is not pressed within 1 minute after pressing a function pad, the oven display will return to the time of day mode and the
programmed function will be canceled.
Off/cancel
Off/Cancel stops any function except the Clock, Timer and Control Lock.
Clock
This is a 12-hour clock and does not show a.m. or p.m.To Set:Before setting, make sure the oven and Timer are off. Press OFF/CANCEL
to cancel the oven, and press TIMER SET/OFF twice to cancel the timer.1.Press CLOCK.2.Press the TEMP/TIME “up” or “down” arrow
pads to set the time of day.3.Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
■Valid pad press
■Oven is preheated (long tone)
A.Oven rack
B. Bump
26
09-May-2014 18:21:12 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
