Whirlpool LSA 1300, Service Manual

Page: 28 / 32

b) 2
nd
& 3
rd
detection, system waits for consumer intervention to open the Lid
distribute the cloths and then to press start key
c) 4
th
detection will be a permanent Ub error &
the consumer
3) Need to check:
a) Ensure the laundry in a balanced distribution.
b) Check whether the water in the system is completely draining or not.
c) Ensure that there are 24 PIP in the system drive ( Run Line Test Routine
there is any PIP breakage there it will be detected as “PIP”)
d) Ensure that the capacitor doesn’t have degraded.
e) Check whether the system is running smooth.
RID#2.7. POWER ERROR
1) When the input voltage at consumer end falls below 170V & above 270V then “PE”
error will be detected.
2) Need to check:
a) Ensure that the Input voltage is above 170V & below 270V
b) Check for PCB operation.
RID#2.8. LID OPEN ERROR
1) If there is no feedback from Lid Switch, then “Lid Op
getting the feedback.
2) Need to check:
a) Ensure the Lid is firmly closed
b) Check for Lid switch operation & its connections
c) Check for PCB operation.
RID#2.9. tSC ERROR
1) If Keys are shorted, then ‘tSC’ error will be popped & this error is applicable only in
Test Routines.
2) Need to check:
a) Ensure that there is a required interval given while invoking Test Routines.
b) Check for Keys shorted in User Interface
CONTROL COMPONENTS AND SPECIFICATION
detection, system waits for consumer intervention to open the Lid
distribute the cloths and then to press start key
detection will be a permanent Ub error & the same cannot be rectified by
the consumer
Ensure the laundry in a balanced distribution.
Check whether the water in the system is completely draining or not.
Ensure that there are 24 PIP in the system drive ( Run Line Test Routine
here is any PIP breakage there it will be detected as “PIP”)
Ensure that the capacitor doesn’t have degraded.
Check whether the system is running smooth.
When the input voltage at consumer end falls below 170V & above 270V then “PE”
rror will be detected.
Ensure that the Input voltage is above 170V & below 270V
Check for PCB operation.
If there is no feedback from Lid Switch, then “Lid Open” error will be popped till
getting the feedback.
Ensure the Lid is firmly closed
Check for Lid switch operation & its connections
Check for PCB operation.
Keys are shorted, then ‘tSC’ error will be popped & this error is applicable only in
Ensure that there is a required interval given while invoking Test Routines.
Keys shorted in User Interface
AND SPECIFICATION SERVICE MANUAL
Page | 28
detection, system waits for consumer intervention to open the Lid
the same cannot be rectified by
Check whether the water in the system is completely draining or not.
Ensure that there are 24 PIP in the system drive ( Run Line Test Routine if
here is any PIP breakage there it will be detected as “PIP”)
When the input voltage at consumer end falls below 170V & above 270V then “PE”
Ensure that the Input voltage is above 170V & below 270V
n” error will be popped till
Keys are shorted, then ‘tSC’ error will be popped & this error is applicable only in
Ensure that there is a required interval given while invoking Test Routines.