Whirlpool GLT3057, Owner'S Manual

Page: 14 / 40

14
Style 2: The cap does not have a slot and requires a wrench
to be removed.
Remove the access cap by using a wrench, turning the
access cap counterclockwise.
Remove the spring retainer from the cap by pushing against
the flat side of the spring retainer. Look at the spring retainer
to locate the "NAT" or "LP" position. Turn over the spring
retainer so the "LP" is showing on the bottom. Snap the spring
retainer back into the cap. Reinstall the cap onto the regulator.
A
B
C D E
A. Access cap
B. Gasket
C. Gas pressure
regulator
D.
LP position
E.
NAT position
4. Test the gas pressure regulator and gas supply line.
The
regulator must be checked at a minimum 2.5 cm water
column above the set pressure. The inlet pressure to the
regulator should be as follows for operation and checking the
regulator setting:
Propane Gas:
Minimum pressure: 10" (25.4 cm) WCP, 2.49 kPa (0.36 psi)
Supply pressure: 14" (35.56 cm) WCP, 3.5 kPa (0.50 psi)
Gas Supply Pressure Testing
Line pressure testing above 1/2 psi (3.5 kPa) gauge
14" (35.5 cm WCP)
The cooktop and its individual shut-off valve must be
disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of
1/2 psi (3.5 kPa).
Line pressure testing at 1/2 psi (3.5 kPa) gauge
14" (35.5 cm WCP) or lower
The cooktop must be isolated from the gas supply piping
system by closing its individual manual shut-off valve during
any pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa).
5. If they are installed, remove the burner grates.
Use the following chart to match the correct gas orifice spud
with the burner location and model being converted.
Propane Gas Orifice Spud Chart
Burner Rating
Color Size
5,000 BTUs Red 0.66 mm
A
A. Size stamp
or color
9,100 BTUs Yellow 0.88 mm
9,100/11,000 BTUs Brass 0.93 mm
11,000 BTUs Blue 1.00 mm
13,000 BTUs White 1.08 mm
Four Burner Models
Model No.
Right
front
Right
rear
Left
front
Left
rear
SCS3017
SCS3617
Red
Red
Brass
Blue
Brass
Blue
Yellow
Brass
GLT3057 Blue Red Blue Brass
KGCC706
KGCC506
Red Blue White Brass
W3CG3014
ICS333
Red Brass Blue Brass
Five Burner Models
Model No.
Right
front
Right
rear
Center
Left
front
Left
rear
GLT3657
Blue Red Brass Blue Red
KGCC766
KGCC566
Red Blue Brass White Red
KGCV566 White Red Brass White Red
Burner Locations
B
D C
E
A
A. Left front
B. Left rear
C. Center
D.
Right rear
E.
Right front
6. Remove all burner caps and burner bases.