16
3.
Determine the type of regulator you have:
Style 1:
The cap has a slot and "LP" printed on it.
Remove access cap by using a flat-blade screwdriver or coin,
turning the access cap counterclockwise.
The gas pressure regulator has two settings which are
stamped on either side of the cap. Turn the cap and reinstall
into regulator with the stamp "NAT" visible from the outside of
the regulator.
NAT
Style 2:
The cap does not have a slot and requires a wrench
to be removed.
Remove the access cap by using a wrench, turning the
access cap counterclockwise.
Remove spring retainer from the cap by pushing against the
flat side of the spring retainer. Look at the spring retainer to
locate the "LP" or "NAT" position. Turn over the spring retainer
so the "NAT" is showing on the bottom. Snap the spring
retainer back into the cap. Reinstall the cap onto the regulator.
A
B
C
D
E
A. Access cap
B. Gasket
C. Gas pressure
regulator
D.
NAT position
E.
LP position
4.
For more information regarding gas installation requirements
see the Gas Supply Requirements section of your Owner's
Manual.
5.
If they are installed, remove the burner grates.
Use the following chart to match the correct gas orifice spud
with the burner location and model being converted.
Natural Gas Orifice Spud Chart
Burner Rating
Size
5,000 BTUs
1.09 mm
A
A. Stamped
number
6,000 BTUs
1.25 mm
9,100 BTUs
1.55 mm
10,500 BTUs
1.61 mm
12,500 BTUs
1.74 mm
17,000 BTUs
2.15 mm
Four Burner Models
Model No.
Right
front
Right
rear
Left
front
Left rear
SCS3017
SCS3617
1.09 mm
1.74 mm 1.74 mm 1.55 mm
GLT3057
1.74 mm
1.25 mm 1.74 mm 1.55 mm
KGCC706
KGCC506
1.25 mm
1.74 mm 2.15 mm 1.55 mm
W3CG3014
ICS333
1.09 mm
1.55 mm 1.61 mm 1.55 mm
Five Burner Models
Model No. Right
front
Right
rear
Center Left
front
Left
rear
GLT3657
1.74
mm
1.25
mm
1.55
mm
1.74
mm
1.25
mm
KGCC766
KGCC566
1.25
mm
1.74
mm
1.55
mm
2.15
mm
1.25
mm
KGCV566
2.15
mm
1.25
mm
1.55
mm
2.15
mm
1.25
mm
Burner locations
B
D
C
E
A
A. Left front
B. Left rear
C. Center
D.
Right rear
E.
Right front
6.
Remove burner cap.
7.
Using a T20
®
TORX
®
screwdriver, remove the burner base.
NOTE:
Remove one burner base at a time and then replace
after converting. Do not disassemble entire cooktop.
A
B
C
D
A. Igniter
electrode
B. Gas tube
opening
C.
Burner cap
D.
Burner base
Summary of Contents for GLT3057
Page 38: ...38 Remarques ...
Page 39: ...39 Remarques ...
