Whirlpool GJC3034G, Owner'S Manual

Page: 20 / 42

3-4
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the cooktop, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
REMOVING THE INDICATOR LIGHT, AN ELEMENT
CONTROL, A COIL RECEPTACLE, & THE T.O.D.
1. Turn off the electrical power to the cooktop.
2. Raise the maintop and position the sup-
port rod against the front of the burner box
(see Figure 3-6).
Refer to Figure 3-7 for the following steps.
3. To remove the indicator light (inset #1):
a) Disconnect the two wires from the ter-
minals.
b) Press in on the two locking arms and
unclip them from the cooktop, then push
the indicator light body up and out of
the maintop opening.
4. To remove an element control (infinite
switch)(inset #2):
a) Remove the control knob from the con-
trol stem.
b) Remove the two screws from the ele-
ment control.
c) Remove the two screws from the switch
box cover and remove the cover.
d) Disconnect the wires from the control
terminals and remove the control and
its rubber seal.
5. To remove a coil receptacle (inset #3):
a) Unplug the coil element from the recep-
tacle.
b) Remove the reflector bowl.
c) Remove the screw from the receptacle
bracket.
d) Disconnect the two wires from the con-
trol terminals.
6. T o remove the T.O.D. (inset #4):
a) Disconnect the two wires from the ter-
minals.
b) Remove the two screws and remove the
T.O.D. from the switch box.
Figure 3-6