Tumble Dryer
Model:AWD60A
Page 3
WALL MOUNTING INSTRUCTIONS
The dryer can be mounted on a wall in the inverted position only, by following these
instructions.
Invert the dryer so that the control panel is at the bottom (see figure 4) this allows
easier access to the controls.
1. Determine the location of the dryer on the wall and mark the bracket position.
A minimum of 50 mm is needed between the top of the dryer and the ceiling for ease of
installation.
If mounting above a top load washing machine, allow sufficient room to open the lid of the
2. Fix the wall hanging brackets to the wall securely (e.g. into the stud).
If the studs are too far apart, fit a timber slat to the studs then mount the brackets onto
the slat. The distance between each bracket is 553 mm as per diagram.
553 mm
Wood screws
washer.
TOOLS REQUIRED
For plaster or Drill & 3 mm bit 1
timber wall Phillips head screw driver 1
Description Plastic spacers 2
Wall hanging brackets 2
Hanging hooks 2
Wood screws, 12 g x 50 mm 4
WALL MOUTING KIT INCLUDES
Screws for hanging hooks
and plastic spacers
6
Warning: Ensure that the screw and nut of the Wall Hanging Brackets are tightened
during installation, if required. Regularly check all the screws and nuts and
tighten, if required. Do not overtighten.
