5019 318 33208
SAFEGUARDING THE ENVIRONMENT
1. Packaging
Packaging materials are 100% recyclable and are marked with
the recycling symbol
. Dispose of the appliance in conformity
with local environmental regulations. Packaging materials (plastic
bags, polystyrene, etc.) can be dangerous for children and should
be kept well out of their reach.
2. Product
This appliance is marked in compliance with European Directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is scrapped suitably, you can help
prevent potentially damaging consequences for the environment
and health.
The symbol
on the appliance or accompanying
documentation indicates that this product should not be
disposed of as unsorted municipal waste but must be taken to a
collection point for the treatment of WEEE.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal.
For further information on the treatment, recovery and recycling
of this appliance, contact your competent local authority, the
collection service for household waste or the shop where you
purchased the appliance.
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
IMPORTANT!
• The appliance is not intended for use by young
children or infirm persons without supervision.
• Young children should be supervised to ensure that
they do not play with the appliance.
1. Do not connect the appliance to the mains electricity supply
until installation is completed. Always disconnect the hood from
the mains before performing any cleaning or maintenance.
2. Do not “flambé” food under the hood. Naked flames could
cause a fire.
3. Do not leave pans unattended when frying. Cooking oil can
catch fire.
4. Regular cleaning and maintenance is essential to correct
functioning and good performance. Regularly remove dirt
deposits. Regularly clean or replace filters. Never use
flammable materials as hoses for extracted air.
5. If the hood is used together with non-electrically powered
appliances, ambient negative pressure must not exceed 4Pa
(4 x 10
-5
bars). Make sure the room is adequately ventilated.
6. If the hood is used in extractor mode together with cookers,
ambient negative pressure must not exceed 4 Pa (4 x 10
-5
bars).
7. Exhaust air must not be conveyed through the same flue used
by the heating system or other non-electrical appliances.
8. The room must be adequately ventilated when the hood is
used together with appliances powered by gas or other
fuels.
9. When replacing the bulbs, first ensure that they are cold.
Note: always wear work gloves for all installation and
maintenance operations.
Electrical connections
Before connecting the hood to the power supply, make sure the
voltage specified on the dataplate matches that in your home.
The dataplate is located inside the hood behind the grease filter.
If the appliance is fitted with a power cable and plug, the plug
must be placed in an accessible position.
If the hood does not come pre-fitted with a mains plug, fit one
that conforms to applicable standards or use a double-pole
switch with a minimum breaking gap of 3 mm.
Replacement of the power supply cable with power plug or
flexible cable may only be carried out by an authorized Service
Centre or a qualified electrician.
Cleaning the hood
Important!
Failure to remove oil and grease (at least once a
month) could lead to fire.
Use a soft cloth with a neutral detergent. Never use abrasive
substances or alcohol.
Before using the hood
Please read these instructions carefully and keep them for future
reference, in order to ensure best use of your hood.
Packaging materials (plastic bags, polystyrene, etc.) can be
dangerous for children and should be kept well out of their
reach.
Make sure the hood has not been damaged during transport.
Installation, electrical connections and replacement of the mains
lead with a plug or new flexible cable must be carried out by a
qualified technician in compliance with local safety regulations.
This appliance is designed to be used only by adults.
Declaration of conformity
This product has been designed, manufactured and sold in
conformity to the following standards:
- safety objectives of "Low Voltage" Directive 73/23/EEC
- protection requirements of “EMC” Directive 89/336/EEC
amended by Directive 93/68/EEC
Troubleshooting guide
The hood does not work
• Is the plug properly inserted in the power socket?
• Is there a power failure?
• Is the fuse blown?
The hood is not extracting efficiently:
• Is the right speed selected?
• Do the filters need cleaning or replacing?
• Are the air outlets blocked?
The light does not work:
• Does the bulb need replacing?
• Is the bulb correctly fitted?
• Is the fuse blown?
AFTER-SALES SERVICE
Before calling the After-sales Service
1. Check if you can fix the problem yourself (see
"Troubleshooting guide")
2. Switch the hood off and then on again to check if the
problem has gone.
3. If the problem persists, contact the After-sales Service.
Specify:
• the nature of the problem,
• the model of hood, stated on the data plate inside the hood,
accessible by removing the grease filters.
• your full address,
• your telephone number and area code,
• the service code (the number appearing below the word
SERVICE on the data plate inside the hood behind the grease
filter).
If any repairs are needed, contact an authorized Service Centre
(to ensure that only original spare parts are used and that repairs
are made correctly).
Failure to comply with these instructions may compromise the
safety and quality of the product.
D
F
NL
E
GB
P
I
GR
31833208.fm Page 11 Tuesday, July 18, 2006 10:40 AM
