75
TROUBLESHOOTING GUIDE
Oven not working:
•
Check for the presence of mains electrical power
and if the oven is connected to the electrical
supply.
•
Turn off the oven and restart it to see if the fault
persists.
IMPORTANT:
•
Check that the oven control knob is not turned
to “0” or to the “lamp” symbol
.
- If the electronic programmer (depending on
model) display presents the message
“
”, consult the product description
sheet provided separately and/or the
electronic programmer description.
- If the electronic programmer (depending on
the model) presents the message “
F
XX
”,
contact the nearest After Sales Service.
Specify in this case the number that follows
the letter “
F
”.
- Check that the mechanical programmer
(if provided) is turned to “manual”.
AFTER SALES SERVICE
Before contacting After Sales Service:
1.
Try to solve the problem yourself following the
points described in “Troubleshooting Guide”.
2.
Turn off the appliance and restart it to see if the
fault persists.
If after the above checks the oven or cooktop
are still not working properly, contact the
nearest After Sales Service.
Please give:
•
A short description of the fault;
•
the oven type and model;
•
the service number (number after the word
Service on the rating plate), located on the
right hand edge of the oven cavity (visible
when the oven door is open). The service
number is also indicated on the guarantee
booklet;
•
your full address;
•
your phone number.
In the event the oven must be repaired, contact
an
authorised After Sales Service,
(use of original
replacement parts and proper repair is guaranteed).
Failure to comply with these instructions may
compromise the safety and quality of the
product.
DECLARATION OF CONFORMITY
• These appliances is suitable for contact with
foodstuffs and complies with EEC (CE)
Regulation n. 1935/2004.
• This appliance is designed to be used for
cooking only.
Any other use (for example, for room
heating) is considered as improper use and
potentially dangerous.
• The appliance was designed, manufactured
and sold in compliance with:
- safety objectives of the “Low Voltage”
Directive 2006/95/EC (which replaces
73/23/EEC and subsequent
amendments);
- the protection requirements of EMC
Directive 2004/108/EC;
- the requirements of Directive 93/68/EEC.
