5 - SET-UP FOR OPERATION
5.3.7 Gas oven main burner (Fig. 2A)
Unscrew the fastening screw (19) of the main burner and replace it
with a new one. See also oven burner cleaning, para. 6.7).
After any maintenance or repair work, replace the con-
trol panel and the lower panel.
After replacing gas input components, check operation
again and test for leakage.
5.3.8 Heating elements for electric oven GN 2/1 (fig. 4A)
Unplug the appliance from the electrical mains!
The lower heating element is placed under the bottom. The upper
heating element is attached to the top of the cooking chamber.
To remove the heating elements, loosen the screws that attach them
to the corresponding flange, and pull the heating elements and rela-
tive wires forward.
Use a screwdriver to disconnect the wires and install a new heating
element in reverse order.
5.3.9 Heating elements for electric oven GN 1/1 (Fig. 4B)
Unplug the appliance from the electrical mains!
The lower heating element is placed under the bottom. The upper
heating element is attached to the ceiling of the cooking chamber
and the fan heating element is behind the back wall.
To remove the heating elements, remove either the bottom and/or the
rear wall, loosen the screws which fasten the heating element to the
oven, and pull the heating element and relative wires forward.
Disconnect the wires, and install a new heating element in reverse order.
5.3.10 Fan for electric and gas ovens GN 1/1 (Fig. 4B)
To replace the fan, remove the fan cover rear wall. Remove the fan
(1) by loosening the locking nut (2).
Loosen the bolts (3) that hold the plate (4) which supports the motor
(5) on the oven, pull the plate forward with the motor and relative
wires, remove and re-install in reverse order.
5.3.11 Solid top burner (40, Fig. 5)
Remove the cast-iron plate and the control panel after loosening
the visible screws.
Unscrew the nozzle-holder nut (42) and the bolts (46) and replace.
Reassemble following the above procedure in the reverse order.
5.3.12 Solid top tap (55, Fig. 5)
Remove the control panel after loosening the visible screws.
Unscrew the gas and thermocouple unions (51 - 52 - 53 - 54) and
remove them from the tap.
Reassemble following the above procedure in the reverse order
5.3.13 Solid top pilot burner (47, Fig. 5)
Remove the cast-iron plate and work on the pilot.
5.3.14 Solid top ignition plug (49, Fig. 5)
Proceed as above.
5.3.15 Solid top thermocouple (48, Fig. 5)
Remove the control panel after loosening the visible screws.
Unscrew the nut (56) and remove the thermocouple from the pilot.
Reassemble following the above procedure in the reverse order.
064_03
- GAS KITCHENS
17
· 26
07/2007
