15
A hose t hat attaches t o a sink spray can bur st i f it is installed on th e sa me water li ne as the dishwashe r.
If your s ink has one, it is recommended that the hose be disconnected and the hole plugg ed.
Pull the Aqua-Stop hos e completely out from th e storage comp artment located at the rea r
of the dishwasher.
Tu rn water full y on be fo re starting the dish was her.
1
Tighter the screws of the Aqua-Stop hose to the faucet with thread 3/4inch.
The A qua-Stop ho se c onsi sts of double wall s. Th e hose's system guar ante es it s int ervention by blocking the flow
of water in case of the supp ly hose breaking and when the air space between the supply hose itself and the outer
corrugate d ho se is full of w ater.
Turn o ff th e water.
U nscr ew t he Aqua -Sto p ho se f rom the wate r ma ins.
2
3
The a ppl ian c e mu st b e co nne cte d to th e w ater mai ns u sing new hos e-se ts.
The o ld h ose -se ts sho uld no t be re use d.
Wate r pressure must b e between 0,04 MPa and 1 MPa. If the pressu re is below t he min imum
c on sult our Servic e Department for a dvice.
Connect the cold water supply hose to a threaded 3/4 inch connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet valve can get blocked
and damage the appliance.
The water suppl y to the applian ce can also be c onnect ed to the house hot water line (cen tralized sys tem, he ating system),
as long as it doe s n ot exce ed a tempera ture o f 60 C. In this case, the wash cycle time will be shortene d by a bout 15 min utes
and the wa sh efficiency sl ightly red uced.
The connection must be made to t he hot water line following the sa me procedures as tho se for the connect ion to the
col d water line.
1
2
Summary of Contents for ADP8000
Page 1: ...ADP8000 ...
