11
3. Remove the Hex head screw securing the
green ground wire to the evaporator frame.
(Fig. 3-9)
4. Remove the air director vanes from each
side of the evaporator shroud by first lifting
the large tab ( ). then slide the vane back
to release the end tabs from the slots in the
evaporator shroud ( ). Last, pull the
vane away from the air conditioner ( ).
(Fig. 3-10)
5. Remove the four (4) screws securing the
evaporator shroud to the evaporator frame.
(Fig. 3-11)
6. Carefully remove the styrofoam liner from
the back portion of the front panel assem-
bly.
(Fig. 3-12)
If, during this step, the top edge of the tape
securing the styrofoam liner is damaged, re-
move the tape carefully, turn it upside down
and replace it during reassembly. The tape
is visible when the unit is assembled.
Failure to do this may result
in customer complaints.
!
NOTE
7. Remove the five (5) screws securing the
back portion of the front panel assembly to
the divider wall. Then, slide the assembly
forward and off of the base plate.
(Fig. 3-13)
8. Remove the screen surrounding the com-
ponent compartment by pulling it straight up
and away from the air conditioner.
(Fig. 3-14)
Back Portion
of Front Panel
Assembly
Fig. 3-9
Fig. 3-10
Fig. 3-11
Fig. 3-12
Fig. 3-13
Fig. 3-14
14
-- NOTES --
