Whirlpool 8TCEM2760KQ0, Installation Instructions Manual

Page: 16 / 36

16
You can install the 30-minute or 60-minute timing cam (shipped
with dryer) as follows:
1. Unplug dryer or disconnect power.
2. Unlock meter case.
3. Turn the timing cam by hand until the V-shaped notch lines up
below the ratchet tooth.
4. Insert a narrow, flat-blade screwdriver under the timing cam
near the clock shaft. Gently lift cam straight up and off shaft
making sure that the V-shaped notch clears the ratchet tooth.
5. Place new cam (hub side down) over clock shaft. Line up flat
side of shaft with flat side of cam hole. Check that drive lug is
in place.
6. Turn cam until V-shaped notch lines up with ratchet tooth.
7. Press cam down in place on motor shaft. Make sure that
V-shaped notch clears the ratchet tooth.
8. Close and lock the meter case.
CHANGING TO A 30- OR
60-MINUTE TIMING CAM
B
C
D
A
A. Ratchet tooth
B. Timing cam
C. Drive lug
D. V-shaped notch
WARNING
Electrical Shock Hazard
Disconnect power before making cam changes.
Failure to follow these instructions can result in death
or electrical shock.