2
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here.
Tools needed:.
Parts supplied:
Remove parts package from the washer basket. Check that all
parts were included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and see “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your washer/dryer. For further information, please reference the
“Assistance or Service” section of your “Washer/Dryer User
Instructions.”
Alternate Parts
Your installation may require additional parts. For ordering
information, please refer to the toll free phone numbers on the
front page of your “Washer/Dryer User Instructions.”
Location Requirements
You will need
■
A location that allows for proper exhaust installation. See
“Venting Requirements.”
■
A separate 30-amp circuit.
■
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the washer/dryer. See “Electrical Requirements.”
■
#2 Phillips and flat-blade
screwdriver
■
Adjustable wrench that
opens to 1" (2.5 cm) or
⁹⁄₁₆
" (14 mm) open-end
wrench (for adjusting
dryer feet)
■
Level
■
¼" nut driver or socket
wrench
■
Wood block (for leveling)
■
Ruler or measuring tape
■
Wire stripper (direct wire
installations)
■
Knife
■
Vent clamps
■
Caulking gun and
compound (for installing
new exhaust vent)
■
Pliers
■
Scissors
■
Tin snips (for new vent
installations)
A. Water inlet hoses (2)
B. Inlet hose flat washers (4)
C. Rear leveling legs (2)
D. Front leveling legs (2)
E. Plastic strap
F. Drain hose
G. Yellow, single wire hose clamp
H. Silver, double wire hose clamp
A
B
C
D
E
F
G
H
If You Have
You Will Need to Buy
Laundry tub or
standpipe taller than
96" (2.4 m)
Sump pump system (if not already
available)
1" (2.5 cm) diameter
standpipe
2" (5 cm) diameter to 1" (2.5 cm)
diameter standpipe adapter, Part
Number 3363920
Overhead sewer
Standard 20 gal. (76 L) 34" (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain
Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short
Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain
Drain protector, Part Number 367031
Water faucets
beyond reach of fill
hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion, or fire.
