COMPONENT ACCESS
Whirlpool Compact Heat Pump Dryer
n
4-17
Removing the Front Panel
To Remove the Front Panel
1. Unplug dryer or disconnect power.
2. Perform the procedure on page 4-8, “Remove the Door
Assembly” prior to performing the following steps.
3. Perform the procedure on page 4-9, “Remove the Top
Panel” prior to performing the following steps.
4. Perform the procedure on page 4-9, “Remove the Side
Panels” prior to performing the following steps.
5. Perform the procedure on page 4-11, “Remove the
Console/User Interface” prior to performing the following
steps.
6. Remove door lint filter and bottom HX Filter.
7. Remove the two T20 Torx screws on the opposite side of
the door hinge (see Figure 1).
Remove 2
T20 Screws
Figure 1
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
8. Using a T20 Torx driver, remove the 4 inside screws, 2 on
each side of the inner front panel. See Figure 2.
Remove two (2) T20
screws on each side of
inner front panel.
Figure 2
9. Pull front panel away from the front bulkhead.
