11
Pro Series
Furnace Operations Manual
SELECT ITEM:
NITE MODE
Figure 4
Chapter Two — Special Functions
To look at or change a feature, press the
Special
Functions
button. The display will read:
Turn the
Select Knob
clockwise or counterclockwise
until the desired feature is displayed. Press the
Next
button to look at or change this feature. Each feature
will be described in this chapter.
Menu
The
Special Functions
menu allows you to set up the
operating features of the furnace. This menu is reached
by pressing the
Special Functions
button. Most
Special Functions can be preformed while a program
is running, however this is not recommended because
changing the operating features could affect how the
current program runs.
Setting the Night Mode Temperature
and Activation
The
furnace has a
Night Mode
feature that will reduce
the temperature in the muffle and raise the lift to prevent
moisture build up. The
Night Mode
can be started from
idle mode or while a program is running. The furnace will
auto-matically enter
Night Mode
if no buttons have been
pressed for 2 hours, or 45 minutes have passed since the
last run program and no buttons have been pressed.
The furnace comes from the factory with the
Night Mode
temperature set at 150° C. This temperature may be
adjusted from 0 to 400° C. If
Night Mode
is activated
while a program is running, the furnace will go to the night
mode temperature after the completion of the program
and will maintain the
Night Mode
temperature until
any button is pressed or the power is turned off.
To adjust the Night Mode temperature:
1. Press the
Special Functions
button.
2. Turn the
Select Knob
until the display reads
NIGHT MODE TEMP.
3. Press the
Next
button to look at or change
the night mode temperature.
4. Turn the
Select Knob
to change the temperature
as desired.
5. Press the
Next
button to enter the temperature.
After the
Night Mode Temperature
has been set,
follow these steps to activate night mode from idle
mode or during a program.
1. Press the
Special Function
button. The display
will read
“Night Mode”
.
2. Press the
Next
button to activate
Night Mode
.
• To start
Night Mode
at the end of the pro-
gram while a program is running.
• Turn the
Select Knob
to NEXT = NIGHT MODE
Change Idle Temperature
The idle temperature is the temperature at which the
furnace will maintain between programs.
The furnace comes from the factory with the idle
temperatures set at 0° C, so you must adjust this feature
to suit your needs.
1. Press the
Special Functions
button.
2. Turn the
Select Knob
to display CHANGE IDLE
TEMP.
3. Press the
Next
button to look at or change the
idle temperature.
4. The current setting will be displayed. Turn the
Select Knob
to change the temperature.
5. Press the
Next
button to enter the temperature.
Note:
During shipping the muffle might absorb moisture
from the air. So, it is recommended you heat the muffle
to dry the moisture before firing any porcelain. To dry
the muffle, set the idle temperature to 400° C for one
hour and 600° C for one hour. Follow the numbered
instructions in this section to set the ideal temperature
to the temperatures mentioned above.
It is also recommended you keep the furnace ON with
sufficient night mode temperature to prevent moisture
from accumulating inside the muffle. The recommended
temperature is a minimum of 150° C.
SELECT ITEM:
NEXT = NITE MODE
Figure 5
• Press the
Next
button.
• Night mode is activated.
15946 Pro Series English.indd 11
5/9/08 2:51:10 PM
