Page 9
Wiring the Remote Head Assembly...
STEP 1:
Connecting The Waterproof Housing Kit
1.
Insert the harness cable into the Flex Tube. Be sure there is approximately 3 to 5 inches of cable pulled through the other end of the
Flex Tube.
2.
Fit the Locking Cuff onto the flex tube as shown in Fig.1.
3.
Slide the Locking Fixture onto the cable as shown.
4.
Now slide the Primary Shaft Housing onto the cable as shown.
5.
Position the Locking Fixture inside the Primary Shaft Housing.
6.
Fit the Flex Tube completely around the end of the Primary Shaft Housing.
7.
Tighten Locking Cuff around the Primary Shaft Housing.
8.
Insert the Harness/FlexTube assembly though the wiring opening in the remote head.
9.
Secure assembly with Locking Nut.
10. Install cable clamp as shown for strain relief (to keep the wires from moving inside the cable) and tighten securely
STEP 2:
Pinning The Harness Cable
NOTE: The Harness cable can not be pinned until cable is inside the Remote Head housing.
Refer to the following Table for the pinning information for your specific system:
SYSTEMS 106-A & 206-A
NOTE: Both the Driver and Passenger side cables are pinned identically
GREEN
wire
Position A
in the 3 position DEUTSCH connector
BLACK
wire
Position B
in the 3 position DEUTSCH connector
WHITE
wire
Position C
in the 3 position DEUTSCH connector
Driver Side
.............Connect to
OUTLET 2
on the front of the ISP94 power supply
Passenger Side
.....Connect to
OUTLET 4
on the front of the ISP94 power supply
SYSTEMS 106-B & 206-B
Driver Side/End of cable towards Remote Head
RED
wire
Position
A
in the 3 position DEUTSCH connector
BLACK
wire
Position B
in the 3 position DEUTSCH connector
WHITE
wire
Position
C
in the 3 position DEUTSCH connector
Connect to Strobe Light in Remote Head
YELLOW
wire
Position A
in the 3 position DEUTSCH connector
VIOLET
wire
Position B
in the 3 position DEUTSCH connector
BLUE
wire
Position
C
in the 3 position DEUTSCH connector
Connect to Brake, Tail-Turn Signal Light in Remote Head
GREEN
wire
Position A
in the 3 position DEUTSCH connector
BROWN
wire
Position
C
in the 3 position DEUTSCH connector
No Connection/Not used in standard 106-B or 206-B configuration
ORANGE
wire
Auxiliary Wire
Driver Side/End of cable towards Power Supply
RED
wire
Connect (with Set Screw Connectors) to
RED
wire on Harness Kit.
Insert
other end of
RED
Harness Kit wire into
Position 1
