Page 5
15. Position the mounting bracket assembly against the rubber mounting
gasket as shown. Secure this bracket onto the backing plate using
the four, #10 External tooth washers and four, #10-24 x.50 Hex Head
bolts as shown.
16. Locate and install the upper
mounting bracket onto the studs
located on the bottom of the Arges
light
assembly.
Secure
this
bracket using four stand-offs
(included).
IMPORTANT!
A four-position wiring
pigtail has been included and should be
installed at this point. Refer to the
“Wiring” section for detailed electrical
information
pertaining
to
this
installation.
17. Plug the Arges connector into the cable connector and lower the
assembly onto the lower mounting base as shown, making sure that
no wires are pinched between the brackets. Note that the connector
should ultimately be located under the lower mounting bracket.
