Page 2
Important! It is beyond the scope of this manual to provide specific
procedural information relating to vehicle panels and equipment.
Refer to the Factory Service/Assembly manual for detailed
information on how to remove and/or access specific vehicle
components.
Note:
Although the procedure outlined herein is for installation of the
Arges Remote Spotlight onto the driver-side fender, the same steps would
be followed for mounting the Arges on the Passenger-side fender. For
ease of access, it may be necessary to turn the front wheels all the way to
either the left or right before beginning this procedure.
1.
Position the template provided onto the vehicle fender, making sure
that the appropriate edges are flush with the edges of the fender.
When the template is properly aligned, use a center punch, mark the
locations of the 6 holes to be drilled.
2.
Using a center punch or similar tool, mark the locations of the 6 holes
to be drilled.
Remove the template and in the areas marked, create the following
holes:
• Four (4) clearance holes sized for #10 hardware. These are the
mounting holes.
• One (1) clearance hole sized for #8 hardware. This hole will be
used to hold the backing plate in position.
• One (1) hole 1.25” in diameter. This will be the wire passage hole.
Be sure to thoroughly de-burr all holes before proceeding.
IMPORTANT! The following section provides one procedure that was
tested and proven to be effective at this specific phase of the
installation process. You may find an entirely different method works
better for you.
