Remote
SAFEPATH
Manual Sheet
39
of
50
Rev. C December 1998
Module Description
Introduction
The thirteen modules in the SAFEPATH product line which can be used in the Remote SAFEPATH are:
1. Supervised Audio System Mother Board (SAMB-A)
2. Supervised Audio System Common Control Module (SADC)
3. Supervised Audio System Amplifier/Signal Circuit Module (SAA-10S)
4. Supervised Audio System Amplifier/Signal Circuit Module (SAA-10SE)
5. Supervised Audio System Amplifier/Signal Circuit Module (SAA-40S)
6. Supervised Audio System Amplifier/Signal Circuit Module (SAA-40SE)
7. Supervised Audio System Amplifier/Signal Circuit Module (SAA-80S)
8. Supervised Audio System Amplifier/Signal Circuit Module (SAA-80SE)
9. Self Amplified Speaker Control/Signal Circuit Module (SALL-15S)
10. Supervised Audio System Power Supply Module (SAPS)
11. Supervised Audio System Battery Charger Module (SABC)
12. Remote Microphone Station (RMS-1)
13. Line Level Interface Module (LLIM)
Each SAFEPATH panel is configured with:
•
One SAMB-A
•
One SADC
•
Between one and four amplifier modules (any combination of SAA’s and SALL-15S’s)
•
One SAPS
•
One SABC
•
One LLIM
The interior view of the panel with the modules in place is shown in Figure 22. The location of the amplifier modules (SAA and
SALL-15S) is not shown. The amplifier modules may be used in any combination by installing into slots 1 thru 4 in the SAMB-A. A
block diagram of the panel is shown in Figure 23.
Summary of Contents for SAFEPATH RSAPE-B
Page 11: ...Remote SAFEPATH Manual Sheet 11 of 50 Rev C December 1998 Figure 2 Operator s Console ...
Page 16: ...Remote SAFEPATH Manual Sheet 16 of 50 Rev C December 1998 Figure 3 Panel Mounting ...
Page 41: ...Remote SAFEPATH Manual Sheet 41 of 50 Rev C December 1998 Figure 23 Panel Block Diagram ...
