Wheatstone Corporation D-7, Technical Manual, Page: 86 / 92

page A – 6
D-7 / Jan 2007
A P P E N D I C E S
An Example File - Complete
The following listing shows a typical Options Text File for the surface type
covered by this manual. Your actual Options Text File may be somewhat
different, depending on vintage, but the general ideas involved in editing the
file will apply.
// --------------------------------
// METER BRIDGE OPTIONS
// --------------------------------
// Syntax: METERSRC#:?
// # is the meter index (1 right most - 7 left most)
// ? is the meter stream source
// Ø = None, No meter stream (default for index 3 - 7)
// 1 = Switched Meter Bus (default for index 1)
// 2 = ST1 Master Bus (default for index 2)
// 3 = ST2 Master Bus
// 4 = Sub Master 1 Bus
// 5 = Sub Master 2 Bus
// 6 = Sub Master 3 Bus
// 7 = Sub Master 4 Bus
METERSRC1:1
METERSRC2:7
METERSRC3:6
METERSRC4:5
METERSRC5:4
METERSRC6:3
METERSRC7:2
// Syntax: METERMODE:?
// ? is the meter mode (default = Ø)
// Ø = PEAK & AVG
// 1 = PEAK only
// 2 = AVG only
METERMODE:Ø
// --------------------------------
// MIX MINUS OPTIONS
// --------------------------------
// Syntax: MM#:?
// # is the mix minus bus number (1 - 8)
// ? is the mode (default = Ø)...
// Ø = Post Fader, Post ON (default mode)
// 1 = Pre Fader, Post ON
// 2 = Post Fader, Pre ON
// 3 = Pre Fader, Pre ON
MM1:Ø
MM2:Ø
MM3:Ø
MM4:Ø
MM5:Ø
MM6:Ø
MM7:Ø
MM8:Ø