Once the wiring is connected and
everything is working properly (don’t
forget to set the HI/LO gain switch) it’s
time to fasten the TS-1 to the counter.
To do this you need to remove the unit’s two
acrylic sideplates (each held in place by three
philips head screws). You can then drive home
screws through the A and B counter mounting
holes in the bottom plate (sharp point 3/4
inch #8 sheetrock screws recommended).
Once anchored in place, close up the
unit by replacing the sideplates.
Headphone amp frequency response is virtually flat (-1/10dB @20KHz)
SPECIFICATIONS
GAIN:
+5dB LO setting, +14dB HI setting
DISTORTION:
THD+N .003%
IMD .005%
SMPTE DIN .002%
NOISE:
-92dBu 20KHz BW, unweighted
MAXIMUM OUTPUT:
v20dBu
power 650mW
current 120mA
MAXIMUM INPUT LEVEL:
+26dBu
DYNAMIC RANGE:
112dB
CMRR:
80dB
PHYSICAL:
width 5.4”/13.7cm, height 1.8”/4.6cm, depth 3”/7.6cm, weight 10oz/.28kg
Inside view of bottom plate
A
B
front
back
COUNTERTOP MOUNT:
To install the TS-1 you
will need to drill six holes in your countertop: four
thru-holes for wire passage (5/8” diameter spade
bit, shown in red) and two mounting holes (1/8”
drill bit, A and B) for the 3/4” screws that will hold
the unit in place.
A drilling template is included in the packing box.
2
© 2020 by Wheatstone Corporation
v070220
