2
IMPORTANT
Before you begin:
Open, identify and count all parts prior to assembly. Lay out parts on a flat and
non-abrasive surface. You will need the parts identified on page 3 and 4 of this instruction manuals.
NOTE:
IT IS VERY IMPORTANT TO USE GLUE WITH THE DOWELS. EXCESS GLUE CAN BE
WIPED OFF WITH A DAMP CLOTH.
Insert dowel at least half way by tapping lightly with a rubber mallet (not included), IF NECESSARY.
CAM LOCK SYSTEM OPERATION
HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS
1.
Screw the Cam Bolt into the pre-drilled small holes on the panel. Connect both panels together; making
sure the Cam Bolt goes into the pre-drilled hole at the end of the panel with the Cam Lock.
2.
Insert the Cam Lock into the pre-drilled large hole in the panel. Make sure the arrow on the Cam Lock is
pointed towards the Cam Bolt.
3.
Once the Cam Bolt is connected inside the Cam Lock, take a Phillips screwdriver (not included) and
tighten the Cam Lock clockwise.
4.
Plug the Cam Lock Cover into the cross slot of the Cam Locks to conceal the cam.
You are now ready to assemble the KD unit.
How to adjust the European adjustable hinges on doors?
Shipping may cause doors to become out of alignment. If you find that the doors need to be adjusted
slightly, turn the appropriate screw as illustrated below.
1.
TO ADJUST DOOR FORWARD OR BACKWARD.
2.
TO ADJUST DOOR TO RIGHT OR TO LEFT.
3.
TO ADJUST DOOR UP OR DOWN.
1
2
3
GLU
E
X
X
FINAL
1
2
4
3
1
2
3
4
